I got a little bored today so I decided to find a bunch of pm6 and p28 pinouts and try to decifer a conversion harness and make it into a nice schematic. Well I think i've got it all done. It's in 3 Excel files, very small in size.

Anyone wanna host it? or check it out for errors?

 

I'll host it, how long did it take you? hopefully it's not too big to send to my e-mail turbasco@hotmail.com

 

took me a few hours on and off here @ work. I'm at home now so I'll send it over tomorrow morning. It's just a plain ------ sheet nothing fancy. 3 in total.

1. obd0 pinout + wire colours + wire functions
2. obd1 pinout + wire colours + wire functions
3. obd0 -> obd1 correction sheet.

total is less then 200kb.

 

because I'm hosting this I think I get to laugh at your canadian spelling of colors, you guys are alot of fun.

have you actually made the harness yet? I have a pm5 ecu that I'm probably going to end up scraping so I can use the connector to make the conversion harness, then hopefully I can get my ecu with the plug still attached. do you know where to get these plugs if you don't have them?

 

find a 92-95 ex/si ecu harness w/ 6" of wires. not easy to find i know that.

I haven't tried to make the harness yet but it all matches the one @ PGMFI

 

sent it over kyle. But I sent it from my work email instead, reply to mike@homemadeturbo.com

l8r

 

here's the deal:
http://1337s.com/files/br_b16a_swap_wires.jpg

the place I'm uploading to doesn't like your excel files, sorry I couldn't host these

 

lol i hate the same problem w/ WTDR. That pic is just a reference of how to interrpret the pin #'s.

 

i'll host tht excel files

xenocron@turboedit.org

 

sent.