for the record it's guinea pig.

sure, I'll try communism for a while, you guys just have to send me some people to try it with, I have a pretty good sized desert near my house, I'll set up an area to host a community.


if I could get an ecu with the plugs and a distributor I'd do it and then test it on my car, any help with that?

 

nice job dude.

I have a couple of questions, where can i get the harness pins so i can do that myself? what about the plug itself?

those pings are hard to get off a regular oem harness, so i was wondering maybe someone knows where to buy those pins.

what about the plugs themselves?

people are making those harness and selling them, they have be getting those plugs and pins from somewhere.

 

junkyards for the obd-1 ecu plugs w/ 6" of wire. and old obd-0 ecu's. People hack up the ecu and take the female plugs from inside the ecu and you can solder right to little metal pins that come out the back (that normally go onto the PCB of the ecu).

 

Here is my "Flate Rate OBD0 to OBD1 Conversion" harness.

...I did a COMPLETE OBD0 to OBD1 change over in 2 hours and 17 minutes. From making the harness, to chipping the ECU, hacking the distibutor, installing everything and starting it up.



..it's not a big deal.

 

Wanna post your pinout schematics?

 

It was some website I found on Geocities that is mirrored in the PGMFI Wiki.

Worked perfectly. Started right up.

 

Would you please post a link? I've tried numerous times to get that Excel file to open, but have had no luck.

 

Links dont work and wont save can someone email it to me sweetlu24@hotmail.com

 

Ditto. rrjadus@yahoo.com
Thanks.

 

http://www.pgmfi.org/twiki/bin/view/...KurtsOBD0-OBD1