Hi all,

this is the problem:

B16A P30 G00 ecu.
it was already chipped before i got it. but had no Eprom in it, and the jumper was cut.

soldered in a jumper,

Opened Chrome -> New file -> selected the P30 jdm ECU and started tuning.
Added launchcontrol, changed the revlimiter, adusted fuel an ignition tables.

programmed the chip, and put it in the ecu, and now the car wont get past 4000 rpm.
CEL goes on after is goes out when going to ignition with the key.
while driving, turn the car off and on, makes you able to go past the 4000 rpm, but CEL stays on.

I dont know if the soldering (done by the previous owner) was done bad, but i think by the looks of it is OK.

I had a similiar problem with an ESI last year. there was no problem with the soldering, it was the NEW File used from chrome.