ryan89crx

i posted but edited what i said...

0b00st0

Do you have a CEL?
What is your setup?

FooK

are you using some sort of emulator or just burning chips?

if emulating, are you sure the changes you're making are being uploaded?

Anubis_4_99

i do have a cel, i ground D4 and got codes 10 and 22.. i have a new sensor for 10, and at the moment i dont really care about 22 since it shouldnt make any diffrence on how the motor runs at idle or cruiseing

my setup is below

D16Z6, stock CR
ported and polished head
eagle rods
vitara pistons
block decked .025
ACL bearings
garret T3/T4 50/63 with HPC coating
PO6 converted to v-tec chipped by xenocron (chips he sent must have got damaged during shipping or something, so i've been trying to make my own map)
RC550 injectors
new adjustable FPR at 45psi for now (old fuel pressure was 60)


i dont have an emulator, i bought a moates burn1 from xeno and some chips from moates and have been trying to sort it out on my own.. i know the maps make it onto the chips because i verify before i even try them in the ecu

i've got my timeing dialed in and verified with a timeing light, about 4 times

any map i make seems to idle around 10.0 and any changes i make dont seem to matter

i've had it driveing for about 3 minutes but it was popping and pretty lean so i stopped, and i cant get it to build boost either anytime i get it semi driveable... but im not as worried about that just yet

Anubis_4_99

im pretty sure its working right, i dont really have a way to test it... i bought it brand new so unless it was faulty from the shop then it should be good to go