tps install?
07-11-2006, 12:39 AM
#11
3.0 BAR
Join Date: Apr 2004
Posts: 9,800
Re: tps install?
Originally Posted by TurbodEG
i mean do i need the butterfly to be wide open or closed? if closed, do i put the little nipple part inbetween the opening on the intake manifold and then turn it until it can bolt down? or what
07-11-2006, 12:39 AM
#12
3.0 BAR
Thread Starter
Join Date: Sep 2005
Posts: 1,995
Re: tps install?
Originally Posted by ****
the groove that the tps sits in on the throttle body shouldnt be that far from just setting it into place...set it in that groove and twist til the holes line up. then set your screws in loosely so you can adjust.
how come when i did it that way i was getting a tps code...now that i installed it with the throttle body all the way open i'm only getting the code 41 no code 7
07-11-2006, 02:59 AM
#14
0.0 BAR
Join Date: Jun 2005
Location: WA
Posts: 0
Re: tps install?
41, isnt that the heater circuit, not the actual o2? or is that 43?
------, install the tps, make sure that tab goes into the back of the tb, then adjust it with the throttle closed until it reads .45v. some people use .32v because i guess thats what the car was set at before, but the manual says .45v. then tighten the bitch down.
the o2 has nothing to do with your tps.
------, install the tps, make sure that tab goes into the back of the tb, then adjust it with the throttle closed until it reads .45v. some people use .32v because i guess thats what the car was set at before, but the manual says .45v. then tighten the bitch down.
the o2 has nothing to do with your tps.
07-11-2006, 08:37 AM
#15
3.0 BAR
Thread Starter
Join Date: Sep 2005
Posts: 1,995
Re: tps install?
i know it has ntohing to do with it....but 41 is the o2 sensor heater according to every list i've looked at...i'm not getting a code from the tps now since after ****'s post i went and put it on the right way...
07-11-2006, 10:28 AM
#18
1.5 BAR
Join Date: Mar 2006
Posts: 835
Re: tps install?
Originally Posted by TurbodEG
it's stock...so the heater is inside the o2 right? i need to check it with a multimeter and if it reads good then i need to change the o2 sensor?
Thread
Thread Starter
Forum
Replies
Last Post
pa2play
Forced Induction
10
05-10-2004 05:25 PM
