I've never seen any of those on pgmfi. Do you have a link?


I was thinking about getting a few of these machined. Especially since 1" round stock comes in 2 foot sections only. The jumper harnesses would need to be like 180-200 for it to be worth the time. I have like 90 dollars into mine in costs only so far.

 

Does it spin the right way? If not, can you fix it?

 

everything spins the right way, firing order is the same usw

 

Half finished the harness tonight. Let's hope it's not a piece of ----.

 

Done yet? Im going to steal your design and use JD's lathe to make my own. Might use it on the new ride.

 

What motor is this ------ engineering come from. corolla? At work and too lazy to look up. kb usage not worth it. at the moment.

 

celica S series engine. Which means it will also work on any 2nd gen MR2 and very carefully Aseries engine. Which is relevant to my interests.

 

If you get to making one before I do, I'll pay you to turn it for me :P I'll even send the metal to make it out of down there.


I had a birthday Wednesday and a barrage of tests all week. I'm going to head down to the electronics surplus place today after school and see if I can pick up some some bundled wire to run the distributor and map wires to the engine bay.

 

Custom machined on an angle grinder and finished in a spec within .00000000001th of an inch with a hand file.

 

nice nog, so which 3sge/gte is it?