jinxy

This is the idea to adapt the Honda distributor to the Toyota s series head.



I need this machined.

More to come.


Expect this thread to be a form of failure, ok?



I need help with this. I have most of it figured out but I need to know what things are what on the honda ecu and possibly score the voltage outputs for the sensors.

This thread continues to be a form of failure, ok?

jinxy

Jd, hold my hand. I'm scared, ok?

rprznt

i'll machine that dist spacer for you, crackhead cheap because im a cnc guy.....

you need to draw it properly and email me.

cheers Dan.

jinxy

awesome, thanks. I still need to figure out what angle the hole for the pin needs drilled and how much of an offset/what angle the prongs that go into the dist need to be at.

I'll have to tdc the engine, check orientation and mark some stuff when I get time.

more work on jumper harness.




The distributor, map sensor and a few other things still need sorted out.


I'm probably going to have to run a subharness for the map, ks and distributor

Smith-02

vtec on your toyota will be awesome. you should use it

jinxy

I am going to try to use it to trigger t-vis.

Smith-02

jinxy

Smith-02

90dx

There was a couple good write ups on pgmfi.org i think it was.Did you find those?Looks like a great way to get cheap quality management for the Toy crowd and i think if a guy was smart he would machine a dozen adapters and make some jumper harnesses to sell.