surging idle (SOLVED, answer at bottom)
09-10-2005, 12:40 AM
#11
3.0 BAR
Thread Starter
Join Date: Apr 2004
Posts: 9,800
Re: surging idle
Originally Posted by EG6Sleeper
i wasnt reading earlier. But you installed a APEXI VAFC? What are your settings. I had that problem with the RPM. I think you might set the VAFC a bit rich. Try lowering the setting. And did you get a resistor box or resistor for those low impendence injectors?
Was the idle ok before you installed the VAFC?
Was the idle ok before you installed the VAFC?
the AFC was supposedly just installed and left zero'ed out and only used as a tach. once i figure out how to use it ill make sure its all set zero'ed out.
no clue but i think its my fault good luck
09-10-2005, 12:19 PM
#16
3.0 BAR
Thread Starter
Join Date: Apr 2004
Posts: 9,800
Re: surging idle
well no one suggested it but I fixed it
Problem: FITV
they have a threaded cap on the inside that slowly backs itself out over time. Pulled it off, tightened it back up, and voila.
http://www.honda-tech.com/zerothread?id=699787
Problem: FITV
they have a threaded cap on the inside that slowly backs itself out over time. Pulled it off, tightened it back up, and voila.
http://www.honda-tech.com/zerothread?id=699787
09-10-2005, 05:28 PM
#19
3.0 BAR
Thread Starter
Join Date: Apr 2004
Posts: 9,800
Re: surging idle (SOLVED, answer at bottom)
Originally Posted by shanerv
so then that only is on 0BD-0 intake manifolds?
Originally Posted by Mista Bone
why pull it off? no need to remove from car to fix............I tighten mine yearly due to ES motor mount inserts.......
Been doing it for 6 years now.........
Been doing it for 6 years now.........
