Taps are cheap, just make it bigger.

 

i dont know but i had a set of harbor freight taps and dies and used a 12x 1.50 tap. it worked for me using the stock bolts.

I did this cause uppon removing the tranny from the junk the rear tranny mount and the driver side mount were the only thing holding the motor/trans as i removed the bolts form the rear trany m ount. Doh!

next time supprt the motor so the weight of the engine doesnt fuc it up on the way out.

 

I can get these taps at work no problem. If you want one overnighted to ya I can do that, taps might be slightly used, but hey its a free tap.

pm me if u want it

 

Well there is the official word on the subject.

Only problem is that you will never run through 12 of the inserts. I just used two on my car and returned the kit, free thread repair FTW.

 

Well after reading your replys yesterday i just said ---- it and tapped th holes with 1/2" x 13 bolts. Should have just dont this in the first place instead of trying to do it the right way. Anyway ***** bolted back up and stiff as a mother. Thanks for the help/input.