Stripped T3 flange bolt holes?
#1
Stripped T3 flange bolt holes?
So I stripped my bolt holes on my turbo flange pretty good. I cant really manuever it out good because my turbo is welded to the DP.
The 2 on the left side went in good after I manhandled them. The two on the right go in about two threads before they pop back out. I get the front one to sort of sit in, but I am rolling with out the back right corner in.
Umm whata ***** to do? I leak exhaust pretty good I am assuming, but it's quiter then it was with the crack. The two flanges lay on each other pretty good though. Should I just throw jb weld on the ****** for the ---- of it?
The 2 on the left side went in good after I manhandled them. The two on the right go in about two threads before they pop back out. I get the front one to sort of sit in, but I am rolling with out the back right corner in.
Umm whata ***** to do? I leak exhaust pretty good I am assuming, but it's quiter then it was with the crack. The two flanges lay on each other pretty good though. Should I just throw jb weld on the ****** for the ---- of it?
Thread
Thread Starter
Forum
Replies
Last Post
idiot-stick
General Discussion
9
08-05-2005 11:28 AM
accordepicenter
General Discussion
11
05-17-2005 12:38 AM