Re: +Rebuild, But Now No ComPreSSioN==
 

when you set the timing turn the top cam gear until your rotor is lined up with the cylender number 1 posistion on the cap. Then you put your engine at TDC. use a screwdriver just to be sure. You can have the timing marks lined up and it still be off. If you need to, pull your valve cover and check the cams while they're rotating. You can see pretty easily whats off if you do it like that and crank it over by hand. If you need to take the head off, just pull the whole damn engine. Its so much easyer that way.

Re: +Rebuild, But Now No ComPreSSioN==
 

distributor is at 1. when the engine is at top dead center, but the intake valves are retarded when i do that and open during compression.

Re: +Rebuild, But Now No ComPreSSioN==
 

take the valve cover off and see where the intake cam is right before tdc?

Re: +Rebuild, But Now No ComPreSSioN==
 

------- spin ur cam 180

meaning take off the valve cover and spin it till its 180degrees from what it is now

Re: +Rebuild, But Now No ComPreSSioN==
 

Id pop the VC off and see exactly what the cam lobes are doing w/ respect to piston position. Pretty quick and easy too.

Re: +Rebuild, But Now No ComPreSSioN==
 

the cam pully is twice the diameter of the crank. so when the crank is at TDC every other time it it hitting where you are telling me to move the cam. So there is no point.

Anyways. I HAVE THE BITCH RUNNING.. CORRECT COMPRESSION IN ALL FOUR CYLINDERS.. BUT I THINK IT IS ONLY RUNNING ON ONE CYLINDER. IT IDLES INCREDIBLY ROUGH, AND THERE IS A "ROCK" IN THE ENGINE (WHICH WOULD MAKE SENSE IF IT WAS RUNNING ON ONE CYLINDER. ALSO TO BACK THAT THEORY UP, I PULLED THE PLUGS, AND 1, 2, AND 4 CYLINDER PLUGS ARE BLACK. AND 2 IS FINE. ANYONE HAVE ANY ADVICE? IM THINKIN FUEL PROBLEMS.. BUT MAYBE N OT.

Re: +Rebuild, But Now No ComPreSSioN==
 

Its an ignition problem.

Re: +Rebuild, But Now No ComPreSSioN==
 

?? well i think its firing, because the plugs are black with soot, but i could be wwrong.. what kind of ignition problem? like no spark? or bad timing? i advanced and retarded the spark timing a few degrees, and it did nothing.

Re: +Rebuild, But Now No ComPreSSioN==
 

oh, and if it helps, i'll try to bring the rpms up to like 3500rpm when i took it for a spin around the block, and the power feels like its running on one cyl, and just cuts out. so that's why i think its a fuel problem. any ideas?

Re: +Rebuild, But Now No ComPreSSioN==
 

your old plugs are fouled from all of the gas. Clean em if you have a spark plug cleaner and they'll work again or buy some new ones.:).