Re-bushing LS rods Need help
#1
Re-bushing LS rods Need help
What material is to be used to rebush these rods from 21mm to 19mm? I am using them in a D block, and need to know what material is used inside the rod where it accepts the wrist pin. Any more info on doing this?
Oh yeah, to those of you who recognize me, I picked up a 14b and a D16Z6 for my 91 rex, currently being put together
Oh yeah, to those of you who recognize me, I picked up a 14b and a D16Z6 for my 91 rex, currently being put together
#2
Re: Re-bushing LS rods Need help
I know this was a while ago, but...I had a local shop do this for me on my b16, you need a pretty extensive machine shop with what's called a "center to center" machine. they machined out the wrist pin end of the rods, and put in some kind of Nissan brass bushing in it.
hope this helps. it was really reasonable to have it done by them so if you cant find anyone locally, shoot me an e-mail ben_inglis@hotmail.com and i'll hook you up with their info, it wouldn't be a huge cost to shop the rods, pistons and pins your using to them and just have them figure it out i'm sure.
Good luck! Ben
hope this helps. it was really reasonable to have it done by them so if you cant find anyone locally, shoot me an e-mail ben_inglis@hotmail.com and i'll hook you up with their info, it wouldn't be a huge cost to shop the rods, pistons and pins your using to them and just have them figure it out i'm sure.
Good luck! Ben
Thread
Thread Starter
Forum
Replies
Last Post
slowcivic
General Discussion
18
05-10-2004 06:44 PM