Bushing GSR rods
11-09-2006, 09:50 PM
#1
1.0 BAR
Thread Starter
Join Date: Dec 2002
Posts: 590
Bushing GSR rods
Jusgt out of curiosity as anyone bushed GSR rods with vitara's? They are a little bit longer and would probably reduce the deck height issue to near stock levels.
From the TT article the vitara pistons sit 1.5mm lower = ~0.060 and gsr rods are roughly 45 thou longer than LS rods.
Just thought that this would bring the comp rate up a little too.
From the TT article the vitara pistons sit 1.5mm lower = ~0.060 and gsr rods are roughly 45 thou longer than LS rods.
Just thought that this would bring the comp rate up a little too.
11-10-2006, 04:12 PM
#4
1.0 BAR
Thread Starter
Join Date: Dec 2002
Posts: 590
Re: Bushing GSR rods
ah, not the rod width but the BE width is 0.858" which is a little too small for the D's 0.892"....
damn I thought I was on to something...
interesting enough the B20A5 uses the same rod as an H23....(off topic)
damn I thought I was on to something...
interesting enough the B20A5 uses the same rod as an H23....(off topic)
Thread
Thread Starter
Forum
Replies
Last Post
bense
Hybrid/Tech
11
10-16-2010 08:39 PM
