I've been preparing everything on my hatch for my dohc vtec swap here soon, and I am trying to do everything clean and the best I can.

I've spent all of tonight redoing my 95 dx wiring harness to add vtec and just plain clean it up. I stripped off all the old electrical tape, cleaned most of the plugs, and now I'm ready to add vtec. I want the vtec wiring ran inside of the harness.

My question is where is the best place to route the vtec wires to? I want them to be in the original location as if this was a Z6 wiring harness.

Here are some pics, it would be cool if someone could just use photoshop or paint to draw where I should route the vtec wires. I would appreciate it greatly





The fundamental stages of weight savings lol



This is what the harness looks like on the side that I'm done with

 

1. knock sensor (if equipped) is usually near the oil filter.

2. vtec solenoid is on the exhaust cam.

3. oil press switch is in the same spot as vtec solenoid