Ok..Finally some progress.....Again :(
#11
Re: Ok..Finally some progress.
ok redid the spark plug wires and now i get a the engine to turn over and it is trying to start every now and a gain i am getting combustion like a small puff. so maybe my timing off. and else im missing.
#12
Re: Ok..Finally some progress.
they say the dizzy fits only one way, but i've seen them fit up to the motor and be 180 degrees off (the straight piece of metal that fits into the motor). maybe try pulling it off and checking to make sure its installed correctly.
#17
Re: Ok..Finally some progress.
Plus when you prime the motor like that you are letting fuel enter everytime. Your cylinders are dumped with fuel and most likely plugs are fouled and not sure how long you have been doin this but washing out rings is a possibility too
#18
Re: Ok..Finally some progress.
If it makes the puffing noises, try going clockwise one more set on the dizzy.
I've had this happen before too. Best bet is what he said...set to tdc and check the rotor iteslf to see where it points.
Originally Posted by CSaddict
Thats funny I swapped Distros and #1 became the upper left. Roll the motor over by hand to top dead center. take off the distro cap. whatever its pointing at is number 1. Then go clockwise.