Ok..Finally some progress.....Again :(
After all that my stater ground was wrong. So my stater is now truning over my engine. The engine is getting gas and my spark plugs are fireing. but the engine is not running on its own. what the next step. why is it not catching. timing? im almost postive the timing is on. when you set the crank timing on the crank pulley which is supposed to be up the red or white line.
|
Re: Ok..Finally some progress.
anyone?
|
Re: Ok..Finally some progress.
First off you firing order is correct right? #1 is actually #1?
|
Re: Ok..Finally some progress.
I would say check your firing order. it's easy to mess this up. Done it before, once, and after hours of checking everything, Checked the timing and vroommm.
|
Re: Ok..Finally some progress.
i know this is elementry but start at the lower left on the dizzy and thats cyl 1 and then it goes clockwise right top left cyl 2. am i wrong.
|
Re: Ok..Finally some progress.
it goes 1-3-4-2 starting at the lower left going clockwise. the white mark is your TDC.
|
Re: Ok..Finally some progress.
Thats funny I swapped Distros and #1 became the upper left. Roll the motor over by hand to top dead center. take off the distro cap. whatever its pointing at is number 1. Then go clockwise.
|
Re: Ok..Finally some progress.
ok will try
|
Re: Ok..Finally some progress.
haha you had the same exact problem as me :P
|
Re: Ok..Finally some progress.
yea well cant work on the pos today its snowing out
|
All times are GMT -5. The time now is 05:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands