i had a problem with my minime i didnt have a map sensor so my car would shut off i got a map sensor and know it dosent shot off but know the idle drops and picks back up and it the temp goes right before the max and it throws me code 10 any help thanks

 

You sure you have all the vacuum lines hooked up where they are supposed to go on that MAP sensor? Or is this a throttle body mounted MAP? Also, your temp could be high and the idle fluctuating due to air bubbles being trapped in the coolant. There should be a bleeder screw on or around the thermostat housing that you can loosen while the engine is running to release those bubbles. That may take care of the temp and idle problem.

 

alright thanks for the advise will try tomorrow morn

 

it didnt have enough of antifrezze thanks

 

No problem. Glad it's running well for you. I'm about to rip down my mini-me for the 2nd time because it's been smoking. I'm just going to do the rings and send the head out to be milled, new guides and seals, and get a valve job. Let's hope this takes care of the smoking, lol.

 

yea man good luck