The b18a1 is in in my ef but the axles dont fit what type of axle do you need for the swap? anyone know??

 

dont fit what? they too long? short? dont fit in the hubs?

but the important question is what intermidate shaft are you using?!?!?!

 

There the right length but dont fit the hubs and im using the stock b18a1 intermediate shaft.

 

going into what car? HF, Si, STD? DX?

 

you need to get hubs from a DX or Si, Std/4speed hubs wont work....if your near seattle i have a set...

 

Ok i finally got ahold of the guy i got the swap from and he had it in a crx hf so i just need the spindles off the hf right? they should go right on the std right?

 

Why would u wanna do that? I would just get a set of stock second gen integra axles and use them...just pull off the dust covers on your dx/si hubs. Besides, bigger is stronger, as far as hubs go...hf hubs are smaller than dx/si's.

 

No, you need DX/SI Hub/Spindles in order to use the Integra Axles in your STD/HF EF Civic/Crx. Btw, also remove the dust seal on the inboard side of the hub. It just makes it fit nicer.

Jeff