How much would stock sleeve hold?..
#1
How much would stock sleeve hold?..
how much boost would stock D16Z6 sleeve hold...assuming i am using aftermarket pistons/rods...
would it hold up to 15 psi?.....
if not how much would pinning it help?...(b4 resleeve $ $)
would it hold up to 15 psi?.....
if not how much would pinning it help?...(b4 resleeve $ $)
#3
Re:How much would stock sleeve hold?..
acuatly not really looking for certain psi...
but aiming for 250+whp...in a D16 with rods and 9.0 pistons...with a T3/04 .48.60, vafc . btm, 440ccs.........would 10 psi do the job?...if it would then i might just forget about teh sleeves and save $600+
but aiming for 250+whp...in a D16 with rods and 9.0 pistons...with a T3/04 .48.60, vafc . btm, 440ccs.........would 10 psi do the job?...if it would then i might just forget about teh sleeves and save $600+
#4
Re:How much would stock sleeve hold?..
I'm running stock sleeves with a built bottom end. 13psi, spikes to 15-16 under load (no wastegate, only a spring). 250 whp should be possible with that setup, but probably not at 10psi. Maybe 14-15 or so, depending on other factors. I gotta get the booger put back together, and then I'm gonna dyno her, so we'll see what she will do at 15psi.
Thread
Thread Starter
Forum
Replies
Last Post
5thgencivickid
Turbo Parts For Sale
26
04-11-2005 09:35 PM
ORiG1NaLKhMeRsTA
Forced Induction
19
09-23-2004 12:13 AM