How much would stock sleeve hold?..

Reply Subscribe

Thread Tools

Search this Thread

10-09-2003, 03:54 PM

Donald125

3.0 BAR

Thread Starter

Join Date: May 2003

Posts: 6,279

How much would stock sleeve hold?..

how much boost would stock D16Z6 sleeve hold...assuming i am using aftermarket pistons/rods...
would it hold up to 15 psi?.....
if not how much would pinning it help?...(b4 resleeve $

10-09-2003, 05:37 PM

turboboy

Guest

Posts: n/a

Re:How much would stock sleeve hold?..

i doubt the stock sleeves would take 15psi for long...i ran 13 for quite some time, but i wouldnt go to 15....i posted my block so we'll see how well that does when i get it all done and boosting again

10-09-2003, 07:45 PM

Donald125

3.0 BAR

Thread Starter

Join Date: May 2003

Posts: 6,279

Re:How much would stock sleeve hold?..

acuatly not really looking for certain psi...
but aiming for 250+whp...in a D16 with rods and 9.0 pistons...with a T3/04 .48.60, vafc . btm, 440ccs.........would 10 psi do the job?...if it would then i might just forget about teh sleeves and save $600+

10-09-2003, 11:23 PM

civicunrest

1.0 BAR

Join Date: Feb 2003

Posts: 357

Re:How much would stock sleeve hold?..

I'm running stock sleeves with a built bottom end. 13psi, spikes to 15-16 under load (no wastegate, only a spring). 250 whp should be possible with that setup, but probably not at 10psi. Maybe 14-15 or so, depending on other factors. I gotta get the booger put back together, and then I'm gonna dyno her, so we'll see what she will do at 15psi.