hey guys i wuz putting my block together today and when i was removing the pistons some sort of c thing with two slots came out and i dont know where they go it was only one and its not a rod bearing could any one tell me where it goes and does the piston have to face a specific way or any way works thank

 

hahahah

 

thanks for the help

 

You can't post something like this and honestly believe anyone is going to do anything but laugh at you. Maybe after that subsides, someone will help you, but right now it's too hard to stop laughing..

The way you worded your post makes it seem like you have no clue what you're doing.. whether that's the case or not is still up in the air.

 

they are thrust bearings and they prevent the crank from moving in and out...

get your manual and look up "thrust bearings" and where they go on the block

as for the rods.... oil hole goes twards the intake side

mike

 

alright i got the pistons the arrows facing the crank i know where the thrust bearings go i need to know know is witch way does the slots face, i found where they go its right by the thrid piston i need to know if they face in or out thanks

 

slots are outwards i believe