DSM 450cc blue top install need help
#12
Re: DSM 450cc blue top install need help
N E Way I think i have a stock resistor box that's why my stock injectors are peak and hold but I may be wrong
I'm leaning towards the seal's i will just have to go and buy the napa seal kit and retry it, might do that tomorrow if no one else has had this problem
I'm leaning towards the seal's i will just have to go and buy the napa seal kit and retry it, might do that tomorrow if no one else has had this problem
#14
Re: DSM 450cc blue top install need help
ok I did look into it as far as knowing i didnt need resistors but i was guessing the reason was that i had a stock resistor box, n e way yea i just wont start and the reason im talking about the seal kit is because i think the stock seals are too thin the injectors sit too far in i think and thats why it not getting fuel properly and not running but thats my guess i just wanted to see if anyone else knew before i went and bought a seal kit that wasnt needed
#18
Re: DSM 450cc blue top install need help
I figured it out i put my stock ecu back in and it started to fire somewhat so i knew it wasnt the fuel getting to the injectors so i tried the chipped ecu and it was hesitant but it started then it was running on 3 cylinders, i figured it was that an injector wasnt spraying so i just let it run and it started to work so i dont know how i did it but it all works now thanx alot
Thread
Thread Starter
Forum
Replies
Last Post
iluvmysh
Engine Management
2
12-14-2004 04:12 PM