d15b7 in crx ?"s
#1
d15b7 in crx ?"s
ok so my engine cam to day. what all will i need to put this engine in the car. im keeping my dpfi and putting my dizzy and intake manifold on the d15b7. not for long just so i know the car will start up with no problems. then ill do the mpfi swap.
will i need to change the motor mounts ?
can i use my stock clutch ?
all the coolant lines the same ?
any info would be great i want to start this tomorrow
i wont be near a computer so i need to know all the info b4 i start the swap
will i need to change the motor mounts ?
can i use my stock clutch ?
all the coolant lines the same ?
any info would be great i want to start this tomorrow
i wont be near a computer so i need to know all the info b4 i start the swap
#2
Re: d15b7 in crx ?"s
I don't know but I am prettysure its been done before. I would start by seeing if the dizzy lines up with atleast one bolt then put on the duel point intake manifold and start it, don't forget the coolant sensor plugs are different and all the coolant lines should be the same
Search more :1
Search more :1
#5
Re: d15b7 in crx ?"s
might have to change the drivers side MOTOR mount that is bolted to the block
Will have to extend the fan switch wiring from the back of the block to the switch on the thermostat housing.
Other than that, they are the same motor and cam, just a crappy DPFI choker intake.
Will have to extend the fan switch wiring from the back of the block to the switch on the thermostat housing.
Other than that, they are the same motor and cam, just a crappy DPFI choker intake.
Thread
Thread Starter
Forum
Replies
Last Post
TTC
General Discussion
16
04-22-2007 03:10 PM
70Challenger
Wanted
1
06-22-2006 01:56 AM