cvjoint/axel help
#1
cvjoint/axel help
howdy, i'm trying to get the shaft and cv joint out of my crx, on the pass side. what all do i have to take off... i've taken everything off except the bottom arm.. and the rotor will not come out... i was told that the axels should just pop out of the tranny, but its not going anywhere.. and like i said i can't get the rotor to come out... should i just hit it with a rubber mallet or what?
Johnny
Johnny
#2
Re:cvjoint/axel help
lol Johnny..
remove the axle nut, remove the low control arm nut, and that should let you pop the head of the axle out of the hub. once that is free, crawl under the car and get a small prybar/flat head screwdriver and pry/pop the axle out of the transmission, be advised that fluid will come up.. It takes one good pop, and it should come right out.
Jeff
remove the axle nut, remove the low control arm nut, and that should let you pop the head of the axle out of the hub. once that is free, crawl under the car and get a small prybar/flat head screwdriver and pry/pop the axle out of the transmission, be advised that fluid will come up.. It takes one good pop, and it should come right out.
Jeff
#4
Re:cvjoint/axel help
The rotor doesnt come off, its just the nut, get a buddy to hold the brake pedal down, and get a large *** breaker bar to break that ****** loose, then pound with a rubber mallet on the end of the axle. (dont ------- mushroom the tip of it, or you are fucked)
Jeff
Jeff
#5
Re:cvjoint/axel help
bah i got it all put together finally. it was just being a bitch and got stuck on... i sound like a newb lol, i didn't mean the axel nut i meant the end of the axel, the huge thing... but i used a rubber mallet and a peice of wood to pound it out...
finally got it though... took me 2 hours
------- bitch crx eat ----!
finally got it though... took me 2 hours
------- bitch crx eat ----!
Thread
Thread Starter
Forum
Replies
Last Post
tman6919
Hybrid/Tech
26
03-09-2007 02:49 AM