cbr929rr itbs for ZC
#11
Re: cbr929rr itbs for ZC
Originally Posted by weaponR_91si
what manifold do you have the itb's attached to?
and did they line up without modification? and lastly are the runners on that intake manifold the same width apart all the way down?
let me know, thanks
and did they line up without modification? and lastly are the runners on that intake manifold the same width apart all the way down?
let me know, thanks
#13
Re: cbr929rr itbs for ZC
use a peice of filter element, like flat or in a roll and make the holes for the factory velocity stack bolts then bolt on the velocity stacks, you still have the v stacks and it is filtered and would look clean like you werent running filters.
looks like the obx manifold would work perfect if it only had like half inch or inch of runner left.
looks like the obx manifold would work perfect if it only had like half inch or inch of runner left.
#14
Re: cbr929rr itbs for ZC
Originally Posted by weaponR_91si
use a peice of filter element, like flat or in a roll and make the holes for the factory velocity stack bolts then bolt on the velocity stacks, you still have the v stacks and it is filtered and would look clean like you werent running filters.
looks like the obx manifold would work perfect if it only had like half inch or inch of runner left.
looks like the obx manifold would work perfect if it only had like half inch or inch of runner left.
#15
Re: cbr929rr itbs for ZC
yeah the vac box
just get a golden eagle vacuum manifold, it has one big inlet on the side and 4 outlets on the bottom i believe, around $35, just reverse it, run one vacuum line from each throttle body to each of the 4 outlets and use the big inlet as the new outlet for the brake booster.
just get a golden eagle vacuum manifold, it has one big inlet on the side and 4 outlets on the bottom i believe, around $35, just reverse it, run one vacuum line from each throttle body to each of the 4 outlets and use the big inlet as the new outlet for the brake booster.
#16
Re: cbr929rr itbs for ZC
those pics are nice but you guys really have to be careful with how long the setup is, i built a set, and there just isnt room to leave like 2 or 3 inches of runners before attaching throttle bodies with v stacks. i recommend just enough to slip the boots over and tighten down, when i build my new manifold i am gonna try to tilt the setup at and upward angle, sort of like the ae86 gts ones. but i only want to use half inch or inch max for the actual runners.
#20
Re: cbr929rr itbs for ZC
Originally Posted by bumblezc
Just go to a tool place and get an air manifold for Pnuematic Tools. It's like 2-5 dollars and aluminum.
http://www.a1manifolds.com/ItemList.aspx
Thread
Thread Starter
Forum
Replies
Last Post