carnkpulley removal ??
#12
Re: carnkpulley removal ??
i picked it up from a local guy y8 .. 80k miles , sat in my house for like 8 months .. i sprayed it with some jb ---- today.. had it on its side and watched it like soak in .. beat it with a rubber mallet tried to pry with a screwdriver. slid the crank over a little and beat the end to try and move the crank and not the gear.. Still nothing . i guess ill keep soaking it. But yea there was a little rust holdin that crankpullet on ..bet the same thing holdin on this gear.. but i just cant get behind it and beat it ya know. i guess if i had the right freakin puller i could use it on that as well if its small enough. i might give that a try if i cant get it in the next few days. busy w/ work anyways so im not in a hurry.
#13
Re: carnkpulley removal ??
or take the flywheel cover off and stick a screw driver or punch in there. so that way the flywheel doesnt move. then use a breaker bar and loosen it. That's what i always been doing. I never mess up any flywheel teeth.
#14
Re: carnkpulley removal ??
Originally Posted by hmtcrxsir
or take the flywheel cover off and stick a screw driver or punch in there. so that way the flywheel doesnt move. then use a breaker bar and loosen it. That's what i always been doing. I never mess up any flywheel teeth.
#15
Re: carnkpulley removal ??
soaked the ****** through like a whole can or this jb penitrating ----.. even tilted the block on its side and watched the lube bubble and sink down in there.. still nothing . i had the the pulled wedged with a screwdriver so it couldnt move . and i beat the ---- outta the end of that crank with a mallet and then a block of wood and bigger hammer.. still nothing lol .. dont know what to do now.. id ude a puller but the bolt for the crank is just too short for the thickness of the puller.
#18
Re: carnkpulley removal ??
i just pulled the crank off with the gear and oil pump and ---- still attached .. ive been soakin the gear and holdit it up by the gear puttin the crankpulled bolt back on and wackin the ****** with a hammer. theres like 1/4 of the end of the crank showing beyong the gear .. so i lube it up and knock it back on and ive done it like 4 times. but the ******* just so loud and its hard holding the gear while hitting it with a hammer .. cranks ------ heavy with just a few fingers holdin it lol... my have to try heating it up
#19
Re: carnkpulley removal ??
Originally Posted by SiTurboD
i just pulled the crank off with the gear and oil pump and ---- still attached .. ive been soakin the gear and holdit it up by the gear puttin the crankpulled bolt back on and wackin the ****** with a hammer. theres like 1/4 of the end of the crank showing beyong the gear .. so i lube it up and knock it back on and ive done it like 4 times. but the ******* just so loud and its hard holding the gear while hitting it with a hammer .. cranks ------ heavy with just a few fingers holdin it lol... my have to try heating it up
Thread
Thread Starter
Forum
Replies
Last Post