Ahhh what is happening?
07-26-2003, 10:31 PM
#1
1.5 BAR
Thread Starter
Join Date: Dec 2002
Posts: 1,002
Ahhh what is happening?
Ok so i installed the ghetto-fabulous obx intake manifold on my N/A d16a6 in a 90 rex. it looks all shiny and nice but when i start it up it revs to 4 grand and climbs to 5 grand and stays there.
i made a diag of where everything goes and hooked it up just like the stock intake mani. i have checked my wireing like 5 times. Im not sure about the 2 coolant hoses that go to the Electronic air control valve but i dont think that would mess it up this bad. has anyone ever had this problem?? what should i check next?
i wanna get this done b/c the next thing to install is the turbo kit (with lots of pics btw).
i made a diag of where everything goes and hooked it up just like the stock intake mani. i have checked my wireing like 5 times. Im not sure about the 2 coolant hoses that go to the Electronic air control valve but i dont think that would mess it up this bad. has anyone ever had this problem?? what should i check next?
i wanna get this done b/c the next thing to install is the turbo kit (with lots of pics btw).
07-26-2003, 11:01 PM
#3
1.5 BAR
Thread Starter
Join Date: Dec 2002
Posts: 1,002
Re:Ahhh what is happening?
i put every sensor back on, i think its the fast idle control solenoid (Electronic air control valve as Haynes calles it) on the back of the intake mani. but what could be wrong with it, its plugged in and bolted down tight, i have heard i dont even need that sensor. i will unplug that thing and test it tomorrow, i have been installing this pos for 2 days now, im pissed
07-26-2003, 11:21 PM
#5
1.5 BAR
Thread Starter
Join Date: Dec 2002
Posts: 1,002
Re:Ahhh what is happening?
hah ya i put the intake to head one on but the intake to tb one is on order .. will be here tues.. i have run this engine without that gasket for a while though.. the tb is only held on with 3 bolts though.. the 4th one dosent line up.. i will drill that out and torque it down tomorrow.
this reving to high rpm is wierd b/c the tb is completely closed the whole time. it leaking could be very possible
i didnt even think of that. thanks.
this reving to high rpm is wierd b/c the tb is completely closed the whole time. it leaking could be very possible
i didnt even think of that. thanks.
07-27-2003, 01:11 AM
#6
3.0 BAR
Join Date: May 2003
Posts: 1,751
Re:Ahhh what is happening?
sounds to me like you broke or fucked up your tps i guarundamntee it that sucks get one off a junkyard car because if go to a shop youll end up spending at least a couple hundred
By the way i would rather have sex with a woodchipper than put that manifold on my car
By the way i would rather have sex with a woodchipper than put that manifold on my car
Thread
Thread Starter
Forum
Replies
Last Post
turbohf
General Discussion
24
11-23-2004 06:25 AM
