Re:92 DX auto to ls/vtec 5 speed wiring Q's
right, use the original harness on the car.
_________ OBD1 USDM Auto to Manual: remove RP17 and RP18 replace RP18 with a jumper wire |
Re:92 DX auto to ls/vtec 5 speed wiring Q's
Originally Posted by whiterice
right, use the original harness on the car.
_________ OBD1 USDM Auto to Manual: remove RP17 and RP18 replace RP18 with a jumper wire werd, i just found it myself and was about to post it up, i had no idea it was that simple :) |
Re:92 DX auto to ls/vtec 5 speed wiring Q's
replace rp18 with a jumper wire? What does that mean?
P.S. I found my auto to manual pedal swap at the yard today. I got all pedals and the cluch master cylinder for $9!!! (yeah me) :D |
Re:92 DX auto to ls/vtec 5 speed wiring Q's
a straight wire. no resistor,capacitor,etc.
you know like a jumper for the service connector to check a cel. good deal on the manual swap parts! |
Re:92 DX auto to ls/vtec 5 speed wiring Q's
My friend did the same swap except into a 93 ex civic u may wanna get ahold of him his email is shanerv@juno.com he should be able 2 help
|
Re:92 DX auto to ls/vtec 5 speed wiring Q's
but isn't a jumper wire usually connected to two points? ??? (basically just "jumping" a connection that was previously there?)
|
Re:92 DX auto to ls/vtec 5 speed wiring Q's
I'm guessing RP18 has two points(one for each side of whatever electical device was there)so you would replace the part with a straight wire(a jumper).
__________________ Best Car Insurance | Auto Protection Today | FREE Trade-In Quote |
Re:92 DX auto to ls/vtec 5 speed wiring Q's
Originally Posted by Dr.Boost
I'm guessing
|
Re:92 DX auto to ls/vtec 5 speed wiring Q's
how bout i crack open one of my p06's and take pix for you tomorrow steve. and then i'll fly to bfe and hold your hand while you solder. mmmkay?
ok. maybe not the second part. |
Re:92 DX auto to ls/vtec 5 speed wiring Q's
this picture is from a manual tranny, so it's already configured correctly, but an auto tranny will have a jumper on rp17 instead of rp18, so just remove the jumper from rp17, desolder rp18 and solder in a jumper wire, i did one last night, took 1.2 minutes ;)
http://www.newbieforces.com/files/ecub4desolder.jpg |
All times are GMT -5. The time now is 06:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands