1g crx engine swap
#22
Re:1g crx engine swap
Originally Posted by Semnos
PJ1 is the ECU code...like you have a PM6 etc..I bet you have a PG7 or sumting like tha from a integra right?
PJ1 is the ECU for the browntop ZC....on my ZC blocks it also says ZC1 and I think the Cams might be a bit more aggressive than the integra's engine.
PJ1 is the ECU for the browntop ZC....on my ZC blocks it also says ZC1 and I think the Cams might be a bit more aggressive than the integra's engine.
So, how much you want to sell that PJ1 for?
How about I'll trade you USDM side markers and a USDM cluster? :P
Don't worry about room with the turbo. I had more than enough before I moved up the radiator. I was thinking the same exact thing before I did mine....how the hell will this thing fit in there?
Honestly don't worry about it, all you have to do is to either get the same rad as semnos or you can just move yours forward. I just moved the lower mounts up a little and that's it. I also had to add hood latches because I cut out some ----. I am more happy with the locking hood pins because it makes it more difficult to steal ----.
#23
Re:1g crx engine swap
hahaha well I'll find you one.
I'm going to fix the old rex to sell it...it doesn't run right now stripped threads in the tensioner bolt hole.
The PJ1 is nice and small and has an External Rom if i'm not mistaken...have to go take look.
you can burn a new chip with the OBDOEDIT or an older version of ghettodyne to tune your fuel map...better fine tuning. I just got my EEPROM burner and accesoiries...but I'm going to chip a PM6 Romless ECU..busy making a ROMadapter board for it...it's for my 2nd gen rex
I'm going to fix the old rex to sell it...it doesn't run right now stripped threads in the tensioner bolt hole.
The PJ1 is nice and small and has an External Rom if i'm not mistaken...have to go take look.
you can burn a new chip with the OBDOEDIT or an older version of ghettodyne to tune your fuel map...better fine tuning. I just got my EEPROM burner and accesoiries...but I'm going to chip a PM6 Romless ECU..busy making a ROMadapter board for it...it's for my 2nd gen rex
Thread
Thread Starter
Forum
Replies
Last Post
turbcavi24
Hybrid/Tech
17
04-23-2006 10:23 AM
Chris Harris
General Discussion
33
12-30-2004 10:33 AM
b18vtecrx
Turbo Parts For Sale
0
09-01-2004 01:41 AM
b16_destroyer
Turbo Parts For Sale
0
07-06-2003 05:07 PM