your threads suck, so help me make a gasket
#31
Re: your threads suck, so help me make a gasket
That would be too easy if it worked, which is why i'm not so confident I guess. I'll try beltsanding the flange, but as for the head, it's on the car so that's a no go. I guess just hope it's flat and give it a try.
#32
Re: your threads suck, so help me make a gasket
Originally Posted by AWDstylez
For someone of your intelligence level I would expect a higher level of reading comprehension.
I'm refering to the $1,000 bet that HIS manifold (no one else's, just his) will leak if HE (not you, not anyone else) uses no gasket.
I'm refering to the $1,000 bet that HIS manifold (no one else's, just his) will leak if HE (not you, not anyone else) uses no gasket.
Petey, take the damn manifold off and do it right. Any car that you've gone through from top to bottom is going to require a lot more work than that to sort it and make it right. Bite the bullet and make it so, Number One.
#34
Re: your threads suck, so help me make a gasket
Originally Posted by Joseph Davis
No, I got the picture that Petey's manifold is a lump of dogshit.
#35
Re: your threads suck, so help me make a gasket
Right JD. I don't even have a manifold yet. Was ordering stuff from summit last night and wanted to save on shipping since its 13.99 per order (mostly regardless of what you get), so i'd figure i'd post and see what others thought so I could bundle it in with the rest of my order. Didn't know this was going to turn into a 30+ reply pissing match.
#36
Re: your threads suck, so help me make a gasket
Originally Posted by 98redcavz24
Didn't know this was going to turn into a 30+ reply pissing match.
#37
Re: your threads suck, so help me make a gasket
Originally Posted by Joseph Davis
No, I got the picture that Petey's manifold is a lump of dogshit. What you don't seem to understand is that you are my verbal chewtoy, and I'm enjoying all this at my leisure.
#38
Re: your threads suck, so help me make a gasket
My car will ---- on Tylers car all day everyday. Plus I have a 2nd gear, and a 6th.
#39
Re: your threads suck, so help me make a gasket
Originally Posted by Joseph Davis
Run a belt sander across your manifold head flange to make sure it's flat, and torque it from the center out so it doesn't bow up during installation. You'll be fine.
i sense a certain air of arrogance in you JD that makes my own look benign and negligible.
one thing is certain, using a handheld belt sander where the flat running surface is smaller than the work piece will mean that it gets less flat. not more flat.
using rtv on an exhaust? umm? hmm?
proper mls gaskets with nothing except two flat surfaces is the way to go. other solutions vary between major hack, and slight hack, and out of reach of back yard mechanic.
#40
Re: your threads suck, so help me make a gasket
fel pro karropak makes good gasket material, and comes in different grades. its like like 'permatex' brand of stuff, karropak = felpro diy gaske t rolls