Xgenturbo

Really? ----, I'm almost positive it was a D16A I took that out of, than again, that was 2 years ago, so youre saying that A6 rods will fit my Z6 no problem?

88dx

A6 and z6 rods bolth work

Reddy

where's Silent Chris when you need him?

Xgenturbo

A6 and z6 rods bolth work
Thanks

nonvtec

If you're worried about vitaras sitting too low, deck your block.

Xgenturbo

Is it expensive?

nonvtec

I doubt it, all they have to do is put your block in a mill, takes 15 minutes. I have access to a mill so it doesn't cost me anything

Xgenturbo

ok, but then dosnt that ---- up the aligment of the sleeves? I do have acess to a mill for free, how much should I take off you think?

bambooseven

mill 2mm? that is a whole lot, but I guess it'd work. The only problem is you'd end up getting rid of the whole reason you want those pistons in the first place, the low compression. deck the block like that and you'll end up w/ mid 9.X:1 compression, just like you started out with.

Xgenturbo

9:1 is not bad for 15 psi bro, that was kind of the idea, vitara's in a Z6 make below 8.5:1

Question, after posting the block and after getting it decked, how the hell do I clean the shavings out?