first gen integra LS w/ d16a1, what trans? 5spd manual.
 

trying to find out what trans, its a running car, shifts fine, but no underbody mounts left thanks to rust.

i can get this "engine/trans for $300" is it a deal? is this transmission any good?

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

trans only bolts into 86-89 integra
84-87 crx with d16a1



basically if you dont have that chassis look elsewhere

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

Or you can try the uber-ghetto way and fab up your own custom mounts to fit into an ED/EF chassis. Did that for a friend, solid mount out of plate steel...car rattled like a mofo and like to break ----. :P

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

are the trans any good? ratios and ----

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

That one kid on here bolt a Z6 into his 1G teg. Said that the tranny slid right on but just didn't use a couple bolts.

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

That is true but again the mounts like up in the 1st gen teg/1st gen crx/3rd gen civic



You have to use all the 86-89 clutch/flywheel



They are built tough I believe bisi was using the 86-89 teg trans for sometime

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

I use a 91 crx si tranny with the d16a1

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

CG trans FTW!!

Give $100 for the drivetrain. If the car's rusted away the drivetrain needs gone through.

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

its 'solid' outside of no real rear mounts left, guess it sat on grass. the front half is clean though

Re: first gen integra LS w/ d16a1, what trans? 5spd manual.
 

even for a complete engine to rebuild its wurth the 100