whiteb16crx

so jeff what up with the red crx did you get the crv block yet. and are you getting piston and rods like getting build.

HMT-Admin

Got the block monday, going to paint it up nice, and pin the sleeves. Also need to get the head done, so its going to be a little bit, (and fix the turbokit, lol)

Jeff

I like pizza

waht is pinning the sleeves??

Honda16hb

check out the zc build in the tech section off the front page, there's a picture of it done to the zc sleeves. Basically you pult bolts into the block to support the sleeves.

SolFastD16

also known as "posting" the block

88crxSi

holy ---- Jeff. You ALREADY got the b20 block, damn, you waste NO time.

You must be getting alot of donations to afford all that crap

HMT-Admin

engine was only 840 shipped

J-SMITH69

you have to take into account, jeff's bling factor is through the roof.

88crxSi

aaaahhhhh to have money to burn.. lol Wish I could do that, drop 840 in a pinch

HMT-Admin

it adds up quickly though..

-Hondata intake manifold gasket
-5way valve grind
-New head gasket
-Posts/Pins for block support
-Por15 Engine Paint (maron)
-.63 A/R Exhaust housing
-Balance Injectors
-180 Mandrel 2.5 & 180 1.5 Mandrel & flanges (redoing DP)

I measured today, the stock B18 sleeves are 7.15mm and the B20 sleeves are 7.78mm I thought my eyes were fucked up, guess not, lol...

It should be nice when I'm done, a good 300whp to the ground, I'm just really looking forward for the extra torque..

Jeff