abaz crvtec whats up
so jeff what up with the red crx did you get the crv block yet. and are you getting piston and rods like getting build.
|
Re:abaz crvtec whats up
Got the block monday, going to paint it up nice, and pin the sleeves. Also need to get the head done, so its going to be a little bit, (and fix the turbokit, lol)
Jeff |
Re:abaz crvtec whats up
waht is pinning the sleeves??
|
Re:abaz crvtec whats up
check out the zc build in the tech section off the front page, there's a picture of it done to the zc sleeves. Basically you pult bolts into the block to support the sleeves.
|
Re:abaz crvtec whats up
also known as "posting" the block
|
Re:abaz crvtec whats up
holy ---- Jeff. You ALREADY got the b20 block, damn, you waste NO time.
You must be getting alot of donations to afford all that crap ;) |
Re:abaz crvtec whats up
engine was only 840 shipped ???
|
Re:abaz crvtec whats up
you have to take into account, jeff's bling factor is through the roof.
|
Re:abaz crvtec whats up
aaaahhhhh to have money to burn.. lol Wish I could do that, drop 840 in a pinch
|
Re:abaz crvtec whats up
it adds up quickly though..
-Hondata intake manifold gasket -5way valve grind -New head gasket -Posts/Pins for block support -Por15 Engine Paint (maron) -.63 A/R Exhaust housing -Balance Injectors -180 Mandrel 2.5 & 180 1.5 Mandrel & flanges (redoing DP) I measured today, the stock B18 sleeves are 7.15mm and the B20 sleeves are 7.78mm I thought my eyes were fucked up, guess not, lol... It should be nice when I'm done, a good 300whp to the ground, I'm just really looking forward for the extra torque.. Jeff |
All times are GMT -5. The time now is 03:00 AM. |
© 2024 MH Sub I, LLC dba Internet Brands