DOHCZCEF9

I'm in a hurry and need help ASAP so I'm not sure if this belongs in the management forum or what but it's turbo realated. I'm running a inline pump and I'm wiring up the relay for it now. I need to run the power wire from the relay for the pump that will give power to the pump when my stock pump is activated. Where and what color is the power wire for the stock pump and where is the best place to tap into it. I looked at my haynes manual and the wiring diagram says it's a yellow wire. Well I looked at the two yellow wires under my seat and when I hooked up my Volt meter I was readin nothing on both yellow wires. Thanks for all your guys help.

Turbodelsolman

Im not sure what your asking seeing as how i know absolutely nothing about wiring etc. But, I have an inline pump on my car(shop installed) and i took some pics, their kinda bad, but maybe you can see the wiring. I dunno, hope it will help.









They are not very good pics, but they show a little bit of the wiring. Wish I could help you out more, but i hope this helps for something.

Dr.Boost

This might help. It's for a kill switch, but it should help you. Do you have a test light?
http://www.courtlukens.com/cutoff_switch.htm

__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

Honda16hb

take your your back seat (if it's a hatch) and look at the fuel pump, it's a yellow wire with a black stripe. take some ------- pictures of your fuel pump set up for me!!!!!1