What to do with nipple on compressor housing?
#2
Re:What to do with nipple on compressor housing?
dont just leave it, its a boost source, You can run a vacuum line from their to a wastegate or if u customize it, use it for the boost gauge. do not leave it or u will have a small "boost leak"
#4
Re:What to do with nipple on compressor housing?
lick it, or play with it ...j/k. If you decide not to use it, it's 1/8th NPT threaded. So if you wanna block it off, go to home depot's toilet repair section and get a 1/8th npt plug and block it off.
#7
Re:What to do with nipple on compressor housing?
Originally Posted by quadnie
It's always nice when poster answers his/her own question and everyone got to throw in their 2 cents.
#8
Re:What to do with nipple on compressor housing?
Originally Posted by djfob
yeah it's a nipple....too much work to block off I'll just use it for my boost gauge seeming it fits my vac hose nicely. Thanks guys for your help.
This nipple is best to use for your wastegate as its probably the closest source of boost to the wastegate. Keep in mind this will make the overall system show the wastegate less boost. If you need to up it, buy or make a manual controller and up it until you find the point where you want to be (on your guage).
Good luck.
#9
Re:What to do with nipple on compressor housing?
I hear different things from different people. Some say it's a bad idea to use that as a source for wg then some say to use it as a source for a boost gauge. It does though make sense that you want to see amount of boost going to the map. Hmm what to do? I'm running a vac manifold and kinda wanna run everything off of that but then i would need to find something to block off nipple on housing. It's a td04L so there's no 1/8 fitting just the nipple.
So if I was to hook the nipple to wg it would show less boost. This means that if the stock boost on wg is set a 10 it would actually be at 8 for example.
So if I was to hook the nipple to wg it would show less boost. This means that if the stock boost on wg is set a 10 it would actually be at 8 for example.
#10
Re:What to do with nipple on compressor housing?
Exactly...or less.
On my car...I believe my Tial Spring is ~8 psi. I also have an wastegate elbow...this seems to lower it to 6 psi. After I hooked up my wastegate to the nipple on the turbo, my boost guage was showing 3-4 psi.
So then I just added a MBC and upped it back to 8
On my car...I believe my Tial Spring is ~8 psi. I also have an wastegate elbow...this seems to lower it to 6 psi. After I hooked up my wastegate to the nipple on the turbo, my boost guage was showing 3-4 psi.
So then I just added a MBC and upped it back to 8
Thread
Thread Starter
Forum
Replies
Last Post
Brunopod
Wanted
3
01-28-2012 07:13 AM
1995eghatch
Wanted
1
01-30-2006 06:50 PM