turboing my sol...
#1
turboing my sol...
really, my only question is on my oil lines. i know the return line dumps straight into the oil pan, which is easy. but where the hell does the feed line go. i read an article on here about 2 minutes ago, and it mentioned the rear of the block. on my buddies civic, i noticed his feed line going back there too. where exactly do i attatch that hose? also, what kind of hose do i use for the bottom line? the connector on the turbo is barbed, which leads me to believe i need a rubber hose.
#2
Re: turboing my sol...
you T off where your oil preasure sensor goes(next to the oil filter). then you run your feed line from one hole and replace the oil sesnsor on the other.....might wana get a restrictor too so your seals down blow out over time.
#5
Re: turboing my sol...
Buy a Tuner Toys block fitting with dual ports, in case you want to use an oil pressure gauge. I think you can get the stelthmode oil line kit from tuner toys with teh block fitting actually. the only change i'd make is, go to your local hardware store, and buy a 2" piece of 1/2" OD steel pipe to use in place of the brass fitting that comes with the kit for the pan. this is what I did, so I wouldnt have to jb weld the brass fitting to teh pan.
Thread
Thread Starter
Forum
Replies
Last Post
BLACK_DEL_SOL
Hybrid/Tech
25
04-29-2004 10:14 PM