i am no longer running check valves.. i am using DSM injectors an a SMC +, gave the check valves away..the check valve setup is simple...run the brass t's in series from where you map sensor vacumm port is..with a check valve on the center port of each tee..remember blowing out..if you dont face them the right way they are vaccume leaks..if you have a throttle body mounted map, like i do , make a small plate to bolt onto where the map was, make sure it will seal well against the o ring..drill and mount a 1/8 npt fitting with a barb for the vacume hose.to run from, that way you can run the check valve setup in between..the map sensor on mine had a nipple that the hose fit on..a lot simpler than it may sound..sorry dont have a pic of it though

 

what is a check valve and missing link?

 

if someone can reply to this by explaining how to post a picure from a hard drive, then I will show you guys the check valve thing.

 

you can't post a picture from your harddrive. unless you have a alays on connection, and you share the dir where your picture is, and you write down your IP. and you do lots of other stuff. its not worth it. find a host

 

Wheres Jeffs sweet check valve 'pic'.......

 

that ---- sux, because my FTP expired

 

bah..

*******, lol

 

thanks for posting that pic