though i should share i pick for you fuckers who blow couplers
#11
Re: though i should share i pick for you ******* who blow couplers
+2, theres no indentions where the metal was deformed, one crimp at a time. unless they had a wicked sweet setup on an english wheel.
i wonder if similar could be acomplished with one of those exhaust tubing expanders wiht ---- welded on. like the ones that ------ when you tighten them down.
i wonder if similar could be acomplished with one of those exhaust tubing expanders wiht ---- welded on. like the ones that ------ when you tighten them down.
#12
Re: though i should share i pick for you ******* who blow couplers
Originally Posted by onlyflash944
+2, theres no indentions where the metal was deformed, one crimp at a time. unless they had a wicked sweet setup on an english wheel.
i wonder if similar could be acomplished with one of those exhaust tubing expanders wiht ---- welded on. like the ones that ------ when you tighten them down.
i wonder if similar could be acomplished with one of those exhaust tubing expanders wiht ---- welded on. like the ones that ------ when you tighten them down.
#14
Re: though i should share i pick for you ******* who blow couplers
I kept blowing a coupler too, except I cannot do that due to using thick 2 1/4 exhaust mandrel bends so I just busted out the welder and ran a bead. Works just as good, and you don't see it. Totally homemade.
#15
Re: though i should share i pick for you ******* who blow couplers
Originally Posted by ghettoturbo
i dont doubt it works...but there is no way that perfect bead came from that setup imho
#17
Re: though i should share i pick for you ******* who blow couplers
Thread
Thread Starter
Forum
Replies
Last Post
Paperchase013
General Discussion
25
06-23-2005 10:17 PM
93civicEXT
Turbo Parts For Sale
4
10-22-2004 12:38 AM
bipedbear
Turbo Parts For Sale
5
08-25-2004 11:28 AM