is there a flange for this kind of turbo
#1
is there a flange for this kind of turbo
i need a flange for the exhaust so it seat flush on my manifold.as you can see its kind of rounded i need a flange thats the same on one side and square on the other side here is the turbo https://www.homemadeturbo.com/forum/...446#msg1103446
#2
Re: is there a flange for this kind of turbo
Originally Posted by hangloose
i need a flange for the exhaust so it seat flush on my manifold.as you can see its kind of rounded i need a flange thats the same on one side and square on the other side
#4
Re: is there a flange for this kind of turbo
you need a t3/4-70861 flange. I make them for 29.00 shipped or 35.00 for stainless
paypal= dumbtwat@hotmale.com
paypal= dumbtwat@hotmale.com
#6
#8
Re: is there a flange for this kind of turbo
You can just swap to a normal T3 flanged hotside as well. You can get them cheap. I have one I'd sell. It's a .63, so would be a bit bigger too and flow much nicer. You can also just fill that Volvo flange. Fill it with weld and then grind or sand it down until it's flat. It's not rocket science.
#9
Re: is there a flange for this kind of turbo
Originally Posted by highroller54
you need a t3/4-70861 flange. I make them for 29.00 shipped or 35.00 for stainless
paypal= dumbtwat@hotmale.com
paypal= dumbtwat@hotmale.com
#10
Re: is there a flange for this kind of turbo
Originally Posted by CSaddict
Just mill it down it only cost me $20.
Thread
Thread Starter
Forum
Replies
Last Post
djnikko
Engine Management
1
10-31-2003 09:37 AM