hrm that subject was kinda lame but whatever

so you wanna find out what psi your external wastegate opens fully at. heres some info on how to do this.

so heres what i did. i took an old holley fuel pressure gauge that i had laying around and some brass fitting, and put it in the WG hole, bottom one.


i used my small compressor and barely pumped it up and hooked it up to the rubber hose seen here



now when the WG is full open u read the gauge and u know when the wastegate will open. simple.
any questions post em

 

also remember to have the top on

 

Nice :thumbsup: ...I just needa find the stuff to do this

 

The nipple on the side of the top what does it do?

 

thats for your boost controller.

 

you dont need pics just read what he had to say and use some common sense.
apply pressure to the wastegate spring via some sort of air compressor using a gauge to watch exactly what psi the wastegate arm starts to move at.
its not that difficult

 

yes please host picts again

 

If your like me and just want to know what PSI your gates opening at.
And dont have a compresor or the Holey gauge.
Just driv arround in the car and see what PSI the needle starts to fluter at.
Under boost. Thats your WG opening.
came here from FAQ.
Still looking.