I am new here. I am a member over at superhonda.com and was told i could get some good advice here. I am trying to put a turbo kit together for $2000. I am gonna run a t3/t4 turbo, FMIC, BOV (not sure what brand), and i know i also need charge pipes and oil lines. I need help on fuel mamagement to make my car reliable. I was gonna run Hondata s100 but it is too expensive. So what should i run?? This is for a B16a2.

 

If that is OBD1, look into chipping your ecu and running Uberdata software to burn your own program for your car. Much cheaper!

 

what car? obd ?

 

it is a 92 civic with B16A2 and it is OBD 1. i am running a chipped ex ecu.

 

Just look around. You can do plenty damage with 2g hehe =) Just depends on what your ultimate goal is and how you want your set up. You can all your parts for $500 or you can get all brand new parts for $3000, its really your call. Just stick around and you'll see what you should do and what you shouldn do...

But to start things off how many psi are you hoping to push with that T3/T4? or what is your goal HP? Is the B16A built or stock?

 

The B16 is stock. i dont wanna go all out and build my block up, i want to leave the internals stock. I just want a good street/strip setup. Maybe like 10 PSI.

 

So what should i use for engine management??

 

Uberdata or an AFC with 450's will be acceptable for that psi