Oil drain flange for oil pan.

Reply Subscribe

Thread Tools

Search this Thread

06-13-2003, 12:08 PM

deacon2377

1.0 BAR

Thread Starter

Join Date: May 2003

Posts: 433

Oil drain flange for oil pan.

I was wondering if anyone knew where to get one of those bolt on oil pan flanges so that I do not have to weld anything to my oil pan. I have seen a few on ebay but they are running over $20, is there anywhere to get them cheaper?

Thanks.

06-13-2003, 12:30 PM

turboboy

Guest

Posts: n/a

Re:Oil drain flange for oil pan.

just buy a barb fitting and thread it in...thats what i did

06-13-2003, 12:37 PM

Todd

1.5 BAR

Join Date: Feb 2003

Posts: 702

Re:Oil drain flange for oil pan.

www.turbopiping.com has them for $13 and they are very nice.

06-13-2003, 12:44 PM

deacon2377

1.0 BAR

Thread Starter

Join Date: May 2003

Posts: 433

Re:Oil drain flange for oil pan.

I planned on putting a fitting right into the oil pan but I dont have access to a 1/2" tap to thread the hole. Do you think I could go to a smaller diameter?

06-13-2003, 12:57 PM

Todd

1.5 BAR

Join Date: Feb 2003

Posts: 702

Re:Oil drain flange for oil pan.

I would not go smaller.. And those taps are expensive.. And that oil pan is not very thick.. Thats not alot of support for something as important as an oil fitting.