Oil drain flange for oil pan.
 

I was wondering if anyone knew where to get one of those bolt on oil pan flanges so that I do not have to weld anything to my oil pan. I have seen a few on ebay but they are running over $20, is there anywhere to get them cheaper?

Thanks.

Re:Oil drain flange for oil pan.
 

just buy a barb fitting and thread it in...thats what i did

Re:Oil drain flange for oil pan.
 

www.turbopiping.com has them for $13 and they are very nice.

Re:Oil drain flange for oil pan.
 

I planned on putting a fitting right into the oil pan but I dont have access to a 1/2" tap to thread the hole. Do you think I could go to a smaller diameter?

Re:Oil drain flange for oil pan.
 

I would not go smaller.. And those taps are expensive.. And that oil pan is not very thick.. Thats not alot of support for something as important as an oil fitting.

Re:Oil drain flange for oil pan.
 

---- threading, weld the damn thing on!!!!