motor feels like its under a lot of load after a pull, and I cant keep speed
#1
motor feels like its under a lot of load after a pull, and I cant keep speed
d16y8
afc
dsm 450's
I had some problems with timing, and worked them out. (specifically too much and then I pulled more and it runs ok)
Now it pulls fine to redline regardless of gear( havent tried in 4th or 5th). But after the pull the motor feels bogged down regardless of gear, and I can't accelerate or keep speed. I pull over and it won't rev. I shut it down and wait a minute( or less) and start it up and it runs fine. My afc settings were about -35 till 5k then increasing fuel to -30 at 7k.
My thought is it's too much fuel and the plugs are getting fouled then after it has a sec to sit/burn off the plugs they work again and it is fine. Thoughts?
Nate
afc
dsm 450's
I had some problems with timing, and worked them out. (specifically too much and then I pulled more and it runs ok)
Now it pulls fine to redline regardless of gear( havent tried in 4th or 5th). But after the pull the motor feels bogged down regardless of gear, and I can't accelerate or keep speed. I pull over and it won't rev. I shut it down and wait a minute( or less) and start it up and it runs fine. My afc settings were about -35 till 5k then increasing fuel to -30 at 7k.
My thought is it's too much fuel and the plugs are getting fouled then after it has a sec to sit/burn off the plugs they work again and it is fine. Thoughts?
Nate
#4
Re: motor feels like its under a lot of load after a pull, and I cant keep speed
Originally Posted by danronian
Did you check the plugs?
Sounds to me like you could be right.
Sounds to me like you could be right.
Thread
Thread Starter
Forum
Replies
Last Post
soontobeDA
Forced Induction
5
06-19-2006 05:27 AM
Donald125
General Discussion
17
04-29-2006 12:15 AM