Master Power Help...THanks
#1
Master Power Help...THanks
Does anyone know where i can get a compressor map for a master power turbo?
specs:
Model10019
57trim compressor .50a/r turbine.48a/r stage 3 wheel.
I would like to know a few things about this turbo...
is it capable of 300hp with out redic high IAT's on an LS motor?
When will full boost be achieved?
Will boost carry all the way to red line?
My specs for my setup so far are as follows
Stock b18b1 (redline 7000rpm)
Drag Log Manifold
Drag 2.5in DP...(open downpipe)
2.5in Piping all they way around.
Jonnhy Race Car 6in FMIC
DSM 450cc tuned on crome
Im looking for a fast street car that is capable of 300whp and full boost by 4k-7k with out fall off.
I am planning on using a masterpower turbo b/c i do not want to pay 600 for a garret, if i can do the same thing with 400 for a masterpower turbo.
Judging from what i read, i should be able to get to 300whp at around or maybe 15-18psi. But im not sure, can someone please help me verify this as well.
link to the turbo.. http://partsexpressonline.com/...88981
Thanks
#2
Re: Master Power Help...THanks
More detailed specs on the turbo...
Master Power Turbochargers
Turbine Wheel:
-Model: MP300
-Exducer Diameter: 56mm
-Mayor Diameter: 61.5mm
Compressor Wheel:
-Model: MPA
-Exducer Diameter: 58.1mm
-Mayor Diameter: 84.0
Turbine Housing:
-A/R: .48
-Type: Undivided
-Discharge: 4-bolt
-inlet: T3
Compressor housing:
-A/R: .50
-Air Inlet: 76mm
Master Power Turbochargers
Turbine Wheel:
-Model: MP300
-Exducer Diameter: 56mm
-Mayor Diameter: 61.5mm
Compressor Wheel:
-Model: MPA
-Exducer Diameter: 58.1mm
-Mayor Diameter: 84.0
Turbine Housing:
-A/R: .48
-Type: Undivided
-Discharge: 4-bolt
-inlet: T3
Compressor housing:
-A/R: .50
-Air Inlet: 76mm
Thread
Thread Starter
Forum
Replies
Last Post
LSD Motorsports
General Discussion
19
04-18-2006 11:24 AM