honda_turbo_wannabe

Can someone please just tell me if this is the right setup for this boost controller

Sorry for the crappy scbribble drawing

MerkurColin

WTF does the tee do?

Is it a check valve?

Do this:



You might need to vent the line between the regulator and the top chamber of the wastegate.... maybe.

honda_turbo_wannabe

i dunno wtf that tee is, it just comes with it.

http://www.turbosmart.com.au/index.p...download&id=18

There are the instructions, but i dont get um. I need it for an external tial wastegate

TorganFM

Ok on an internal gate how does it go?

Smith-02

it doesnt, unless you can add a nipple on the internal on the opposite side of the diaphram

TorganFM

So I can't use this style of MBC on an internally gated 14b? I have one of these (not hooked up) and a homemade one on now made from plumbing pieces and a ball and spring but I want something that isn't all ------ed.

MerkurColin

With an internal gate, you just need to put a ball-and-spring valve (Grainger valve, or http://www.boostvalve.com) in-line to the actuator. You could do that with an external gate, too, and leave the top chamber open - that's how I used to have mine set up.

Colin

EG-prince

ask donald, the HMT ching chang meow dealer, he sells them so he should know how to hook them up properly

Smith-02

you might be able to torgan, what sort of mbc are you using?

TorganFM

Donalds ching chong one. I tried using it turned all the way down the way he told me and every time it would act like the WG was unhooked... 15+psi spike when it should've been about 8. My pipe fitting one is working fine though, holds 11psi steady.