Just Finished/installed turbo setup....PICS
#1
Just Finished/installed turbo setup....PICS
Pic's will follow in a few minutes..
It's late in the evening now....
I got some shots during the day.
Here are the specs...
D15B2 block.
D16A6 head/intake
Si tranny
450's
T3/T4E 57 trim A/R.50 and turbine is A/R .36
carb spring wastegate...for now(tomorrow will make a custom bracket for the internal wastegate)
yunkyard Chrysler Intercooler.
Yunkyar Renault aluminum radiator
german make BOV
Turboedit NG48 bin
Running open downpipe for now
Zeitronix LT-2 WBO2 kit
Pic's will come...
The radiator fitted without any cutting or bending anything.
I had to mod the bumper a bit(cut away pieces) for the intercooler and piping to fit.
Will put some black mesh tomorrow to cover it up and make it stealthy.
New yunkyard Rad
I had to put hte radiator a bit sideways, cause it was hitting the turbo if I put t straight.
Bling BOV with Flatblack intake chargepipe
It's late in the evening now....
I got some shots during the day.
Here are the specs...
D15B2 block.
D16A6 head/intake
Si tranny
450's
T3/T4E 57 trim A/R.50 and turbine is A/R .36
carb spring wastegate...for now(tomorrow will make a custom bracket for the internal wastegate)
yunkyard Chrysler Intercooler.
Yunkyar Renault aluminum radiator
german make BOV
Turboedit NG48 bin
Running open downpipe for now
Zeitronix LT-2 WBO2 kit
Pic's will come...
The radiator fitted without any cutting or bending anything.
I had to mod the bumper a bit(cut away pieces) for the intercooler and piping to fit.
Will put some black mesh tomorrow to cover it up and make it stealthy.
New yunkyard Rad
I had to put hte radiator a bit sideways, cause it was hitting the turbo if I put t straight.
Bling BOV with Flatblack intake chargepipe
#7
Re:Just Finished/installed turbo setup....PICS
using an internal wastegate, but right now it's holding on a carb spring...tomorrow I'm going to make a bracket for the wastegate....
The is an old fan from a '87 CRX ZC...I grinded off the brackets and it fit perfectly...it ain't hitting anything and it clears the downpipe by 1" or more..
The casing is made out of metal..not plastic
The is an old fan from a '87 CRX ZC...I grinded off the brackets and it fit perfectly...it ain't hitting anything and it clears the downpipe by 1" or more..
The casing is made out of metal..not plastic
Thread
Thread Starter
Forum
Replies
Last Post
Semnos
General Discussion
16
03-02-2004 04:28 AM