how many people are running 8psi or so on stock blocks more or less
#11
Re: how many people are running 8psi or so on stock blocks more or less
Originally Posted by ghettoturbo
but why go through a "rebuild" just to leave all the stock ---- in there. On a d-series its not worth it imho. You'll spend too much on gaskets, bearings, rings, a timing belt, etc and end up with just a stock motor that you will end up either blowing up or tearing apart again to add in forged ---- anyway. If it runs and isnt already torn apart or smoking, leave it alone.
#12
Re: how many people are running 8psi or so on stock blocks more or less
i have a d15b7 on 9psi daily, get the FJT special...i think it runs u $600 for the ibeams pistons and gaskets to rebuild....and bearings....check him out in the sponsor section.
#13
Re: how many people are running 8psi or so on stock blocks more or less
just looking at all the parts on the motor, general inspection, like bearing wear, micked the pistons. even though one rod was bent, not twisted and there was signs of water in the cylinder. also the fact I'm running like 6psi on the sohc zc in my car right now, I think stock block can handle boost pretty well..... decidisions
I talked to one person on another forum that was really happy with fjt's gaskets... said they looked cheap and the head gasket blew within a couple weeks, got a oem and haven't had problems since.
I talked to one person on another forum that was really happy with fjt's gaskets... said they looked cheap and the head gasket blew within a couple weeks, got a oem and haven't had problems since.
#19
Re: how many people are running 8psi or so on stock blocks more or less
---- taking it all apart swapping the rods, boring, and then just put stock pistons back in it.. If gunna do all that put vatara pistons in it as well.. Were doing a turbo d16 crx at our shop with eagle rods and vatara pistons shooting for 300hp or bust..
Thread
Thread Starter
Forum
Replies
Last Post
lkailburn
Forced Induction
21
12-27-2006 12:20 PM