Help me pick a turbo setup....engine setup inside.
#1
Help me pick a turbo setup....engine setup inside.
Hey, im really looking to go turbo since i completely built my motor around it.
Here is my setup all in a 92 civic dx hatchback.
B16 head - 70mm bbk throttle body, Port matched type-r intake manifold, port and polished head, skunk2 valve train, gsr cams
B18c1 block - Je 9:1 pistons, eagle h-beam rods, lightened LS crankshaft, STR block guard
Transmission - JDM gsr tranny, lsd equipped
Now , can anybody tell me the best setup to use on this? I want to make 300 + whp . Possible? Any suggestions appreciated
Here is my setup all in a 92 civic dx hatchback.
B16 head - 70mm bbk throttle body, Port matched type-r intake manifold, port and polished head, skunk2 valve train, gsr cams
B18c1 block - Je 9:1 pistons, eagle h-beam rods, lightened LS crankshaft, STR block guard
Transmission - JDM gsr tranny, lsd equipped
Now , can anybody tell me the best setup to use on this? I want to make 300 + whp . Possible? Any suggestions appreciated
#4
Re:Help me pick a turbo setup....engine setup inside.
I say you run a tdo6-20g turbo, I have never seen a honda run this turbo before, but i bet it would work. On my car i make 20 psi at around 4500 RPM and im well over 300rwhp. my motor is a 2.0 liter though, but that shouldnt make too much of a difference.
#6
Re:Help me pick a turbo setup....engine setup inside.
car runs a bit hotter with the block guard, not too bad tho. Since i switch to the integra rad its been keeping a bit more cool.
Im thinking of doing a gt30r with a small shot of nitrous....
Oh as for fuel management already running aem ems
Im thinking of doing a gt30r with a small shot of nitrous....
Oh as for fuel management already running aem ems
Thread
Thread Starter
Forum
Replies
Last Post
gon3r
General Discussion
98
05-31-2007 06:43 PM
FooK
Engine Management
22
04-17-2005 08:34 PM
Dr.Boost
General Discussion
27
12-31-2003 05:22 PM